Hi! Thanks for the note. I tried this version and it works wonderfully. Thank you very much, I can connect SplitCam to UFO Capture!!
Nevertheless I experienced some strange functioning. I wanted to connect SplitCam to UFO Capture (among other reasons) to analyze already captured video with it. Now my video is in 720x576 (standard PAL) resolution. I wanted every pixel to appear in its original brightness, so I choose "resolution by source" in SplitCam. Then I could not connect UFO Capture with 720x576 resolution.
On the other hand, either if I set "resolution by source", or any resolution with 4:3 aspect ratio in SplitCam, I can connect UFO Capture to SplitCam with _any_(!) Splitcam supported 4:3 resolution (e.g. 640x480, 800x600, higher, lower, whichever), without changing the resolution setting in SplitCam!
On one hand, I am really happy with that, on the other hand I became doubtful about how the brightness of the pixels in the original video is changed/converted when it comes through SplitCam?
My first questions is therefore: What is "resolution by source" setting supposed to mean?
The second question is: when I see the video config, I see that the capture card software indicates that "625" lines are detected. I guess these are 625 scan lines in the analogue video signal it receives. Now how will these lines become 600, 480, and other vertical resolutions? Can you give me a hint where can I look after this? Thanks!